3D Buster Telink, spol. s r.o.

950	1000	34,2	595-645	4-5

osazení Ido EXFC :

serva SAVOX SH-1257MG digital servo coreless mot. 30g (2,6kg/.07sec)

Our series of EPP aerobatic models was supplemented about biplane 3D Buster. The model is also extremely suitable for having fun – stunt flying in a confined/limited space with no smooth landing surface like a mown grass stripModel is great for 3D flying and for start with aerobatic models.

Designers are Jonathan and Ido Segev from Israel. Both pilots made test flight too.

Power unit is equal on ouraerobatic models with wing spam 1100mm.

what you will need

The RC set           

Transmitter                                     4 channels

Servos                                 4 pc,e.g. HS 65HB (12-18 g), cable 250mm

Split cables for servos     2 x 300mm for rudder and elevator

Receiver                              e.g. Duplex R5 (8 g)

Motor                                    brushless 70 - 90g, KV 1100-1250 (2217/1250)

Controller                            AC, for currents of min. 30 A

Propeller                              e.g. APC 10/4,7

Accumulators                    3S1P LiPol 1600-2200 mAh  (150-190g)

A list of further necessary material: contact glue, medium thick cyanoacrylate glue (well proven is the Flash brand), connectors to accumulators…

A list of necessary tools: modelling knife, soldering pistol, nippers...

Stavba modelu 3D Buster
Stavba standardních EPP modelů je celkem běžná. Proto na těchto fotografiích vidíte pouze, jak jednoduše, rychle a geometricky správně přilepit druhé křídlo a vyrobit spojení horního a dolního křidélka. 

List of parts in the kit:

Wing

4 x wing half of EPP

2 x wing spar(2 x carbon fibre composite wire /1000mm)

4 x diagonal wing spar (2 x carbon fibre composite wire 1,5mm/1000mm)

2 x wing strut of EPP

2 x strut spar(2 x carbon fibre composite 1x3mm/ 190mm)

2 x push-pull rod (2 x carbon fibre composite wire 2,0mm/205mm)

4 x aileron horn (4 x carbon fibre composite wire 2,0mm/35mm)

1 x shring tube 2,0/150mm

Trup…

1 x fuselage of EPP (3 parts)

3 x fuselage strip of EPP

1 x wing baldachin of EPP

1 x tailskid(1 x carbon fibre composite wire 1,5mm/40mm- rest of fuselage stiffener)

1 x undercarriage base of plywood

1 x undercarriage base of glassfibre

1 x motor bearer of plywood

2 x fuselage stiffener(2 x carbon fibre composite wire 1,5/ 780mm/1000mm)

2 x fuselage stiffener(2 x carbon fibre composite wire 1,5/ 180mm)

1x undercarriage

2 x wheel

2 x wheel securing tube

2+2+2 x streamlined wheel pants of EPP

1 x horizontal tail of EPP

2 x stiffener for horizontal stabilizer(1 x carbon fibre composite wire 1,0mm/ 1000mm)

1 x elevator joiner, wooden 3x10x196 mm strip

1 x vertical tail of EPP

4 x hinge

4 x horn

4 x piano wire push-pull rod Ø 1mm

4 x adjustable connector„blimp“

1 x instructions